Support Advanced¶
- Z distance
- Support wall loops
- Base Pattern
- Pattern angle
- Interface layers
- Interface pattern
- Interface spacing
- Normal support expansion
- Support/object XY distance
- Support/object first layer gap
- Don't support bridges
- Independent support layer height
Z distance¶
The Z gap between support interface and object.
Support wall loops¶
This setting specifies the count of support walls in the range of [0,2]. 0 means auto.
Base Pattern¶
Line pattern for the base of the support.
Base pattern spacing¶
Spacing between support lines.
Pattern angle¶
Use this setting to rotate the support pattern on the horizontal plane.
Interface layers¶
The number of interface layers.
Interface pattern¶
The pattern used for the support interface.
Interface spacing¶
Spacing of interface lines. Zero means solid interface.
Normal support expansion¶
Expand (+) or shrink (-) the horizontal span of normal support.
Support/object XY distance¶
XY separation between an object and its support.
Support/object first layer gap¶
XY separation between an object and its support at the first layer.
Don't support bridges¶
Don't support the whole bridge area which make support very large. Bridges can usually be printed directly without support if not very long.
Independent support layer height¶
Support layer uses layer height independent with object layer. This is to support customizing z-gap and save print time. This option will be invalid when the prime tower is enabled.